Rest it on a jack or other sturdy support so that it is in line with the cabinet cutout. Turn power on a breaker. Page 7: Install Oven 1. Verify that all control knobs are in the OFF position.
Turn on power at the breaker. The oven will beep and the clock will appear in the display. The lock icons in the display will blink on and off and you will hear a series of clicks as the oven performs a system check.
Page 10 1. Page 12 4. Installation du four 1. Page 15 Instrucciones Importantes de Seguridad Page 16 1. Se puede instalar el doble horno en una pared o un gabinete. Figura 1: Dimensiones de recorte para el horno sencillo debajo de la cubierta de cocina Figura 2: Dimensiones de recorte para montar un solo horno en un gabinete o la pared Espacio para los pies Page 18 4.
Instalar el Horno 1. Inserte el horno en el recorte del gabinete. Check with your local Canadian distributor or dealer. Print page 1 Print document 21 pages.
Slide-in Electric Ranges with European Convection. Table of Contents. Previous Page. Next Page. Gas ranges with mechanical controls and standard convection pages. Gas free-standing ranges with european convection 53 pages. Page 3: Safety Installation, electrical connections and grounding must comply with all applicable codes. Injury to persons could result. Install anti-tip device packaged with range. Verify that the anti-tip devices are engaged.
See installation instructions. English Destroy the pack- aging after unpacking the appliance. Never allow children to play with packag- ing material.
Page 5: General Information Tape warming drawer shut to keep it from opening while installing the range. During installation, place a portion of the box or a piece of cloth under the range to protect floors.
Check local codes for proper amperage ratings. A four wire connection is preferred. Page 7 Allow a minimum of 30 inches between cabinets where range is to be installed See Figure 2: Cutout Requirements for more information.. In this case, ver- ify that the opening is at least 30 inches. Page 8 13 inches deep from backwall. If nonstandard cabinets are used, care should be taken to alter dimensions accordingly. In Canada, a clearance of 12 mm from range sidewall to cabinet is required.
Page 11 Tip: The knockout panel below the terminal block can be removed from the range to install the strain relief: Remove knockout panel from range, install strain relief in panel and reattach.
DO NOT remove entire range back panel. Page 12 4. Remove screw from bottom end of ground strap. Remove ground strap from center post, rotate so that wide end is at top and attach wide end to range through hole below junction box. Attach green wire on top of ground strap. Tighten Screw. Page 13 9. Tighten all connections securely and replace terminal block cover.
Properly secure strain relief see previous section. The Four Wire Connection above is preferred, but where local codes and ordi Page 14 8. Properly secure strain relief. The range can also be connected via flexible conduit. If using this method, always use the lugs supplied. Note: In Canada, the range is shipped from the factory with the range cord already installed.
Page 15 8. Insert the insulated grounding wire into the lug below the terminal block. Insert stripped end of white wire into the center lug. Secure the clamping- screw. Page Complete The Installation 2. Measure back left corner of opening from floor to top of countertop. Measure back left corner of range to bottom of cooktop trim. Use a wrench to adjust leveling leg until this height is the same as the corner dimension.
Page Service 2.
0コメント